To Wire a 1989 S&S Camper, you have to install the pigtail that runs from the back of the truck to the converter. You need to make sure you have the correct pigtail for the brand and model of truck. You must Run the pigtail up through the bottom of the S & S Camper and wire it to the DC-to-AC converter. After that, connect the electrical wire to the opposite side of the converter and run that wire into the electrical panel. You should Mount the 40-amp breaker to the electrical panel and connect the wire running from the converter to the bottom of the breaker.
You can connect the ground wire to a screw on the side of electrical panel. Then, Pull wire from the electrical panel to the light switch beside the door of the S & S Camper. You have to run another wire from the switch to the light fixture. You need to Insert another wire from the bottom of the light switch and pull it to an outlet. You must Jump one wire from each outlet for any appliances you plan to install in the S & S Camper.
You should Power for the refrigerator, stove, and furnace are required, plus any additional outlets to power such things as a microwave, television or radio. Next, insert the outlets and switches in the electrical boxes where the wire is hanging out. You have to Strip the wires and insert the bare ends in the slots of the outlets and switches. You need to Wire the light fixture so it is active and insert a light bulb. You must Cover each outlet and switch with a cover plate.
Forth, Plug the pigtail in the back of the truck and turn on the breaker. You should check the light and the outlets for power. You can Use a volt meter to check each outlet before plugging in any appliance. You have to install the appliances one at a time and check to ensure they are working properly.
Related posts: